H3c-technologies H3C MSR 20-1X Manual de usuario descargar pdf (Pagina 38)

Figure 31 Set the terminal type

Powering on the Router

Checking before powering on the router

Before power-on, check that:

• The power cord and PGND cable are correctly connected.

• The voltage of the power supply is the one indicated on the label of the router.

• The console cable is properly connected, the console terminal has been started, and the

configuration parameters have been set.

WARNING!

Before power-on, you must be aware of where the power switch is located so that you can disconnect the

power supply in time in case of an accident.

Powering on the router

Step1 Turn on the site power.

Step2 Turn on the power switch on the router.

Checking/operating after power-on

After powering on the router, check that:

1. The LEDs on the front panel are normal.

2. The console terminal display is normal.

For the local configuration, after you power on the router, you can see the startup banner (refer to section

Startup Process on page 32).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 74 75

Sin comentarios

H3c-technologies H3C MSR 20-1X Manual de usuario Pagina 38