
85
Figure 88 Install a memory module
Follow the steps below to remove a memory module:
Step1 Make sure all power interfaces are shut down.
Step2 Press the ejector clips on the two sides of the memory module, and pull the memory module outwards
horizontally until it separates from the ejector clips and forms an angle of 45 degrees to the main board.
Step3 Remove the memory module.
Figure 89 Remove a memory module
Replacing a VPM
NOTE:
The MSR 30-10/30-11/30-11E/30-11F does not support VPM replacement.
VPM Structure
Figure 90 VPM structure
Comentarios a estos manuales