H3c-technologies H3C MSR 50 Manual de usuario descargar pdf (Pagina 21)

• Use the display ipx routing-table command to verify the static route takes effect, and to check

whether the next hop address is not specified or not correct on the non PPP interface.

Routes received from a neighbor router cannot be found by using the display ipx routing-table verbose

command

• Use the display current-configuration command to check whether the maximum dynamic route

number is configured on a per network ID basis, with the command ipx route max-reserve-path. If

it is not configured, the default value 4 is used.

• Use the display ipx routing-table verbose command to check whether the existing dynamic route

number under the destination network ID has reached the maximum number.

• If the upper limit is reached, the newly received routes will not be added to the routing table. You

can use the ipx route max-reserve-path command to adjust the maximum number of dynamic

routes.

1 2 ... 16 17 18 19 20 21 22

Sin comentarios

H3c-technologies H3C MSR 50 Manual de usuario Pagina 21