H3c-technologies H3C WA2600 Series WLAN Access Points Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
7-15
Input the File Name:wa2200_fat.bin
Updating File flash:/
wa2200_fat.bin......................................................
........................................................................................
........................................................................................
..............................Done!
Return to the BootWare main menu, and enter the file control submenu to set the application as the
main application. The system will boot with this application at the next boot. For more information about
how to set the main application, see
Set the selected file as the main application program (loaded when
the system starts).
.
2) If the input file name is the same as the existing one, the system prompts:
The file is exist,will you recover it? [Y/N]
z If you select Y, the system overwrites the original application, and the AP boots with the new
application at the next boot.
z If you select N, the system prompts:
Cancel to overwrite the file.
Failed!
The system cancels overwriting the existing application, and the upgrade fails.
The size of an application is typically big. Even if you change the baud rate to 115200 bps, the upgrade
process takes about 30 minutes. Therefore, it is recommended that you upgrade an application through
an Ethernet.
Upgrading Applications Through TFTP at the CLI
The Trivial File Transfer Protocol (TFTP) is a TCP/IP protocol used for file transfer between client and
server. It provides a simple and low-overhead file transfer service. TFTP provides unreliable data
transfer over UDP and does not provide any access authorization and authentication mechanism. It
employs the timeout retransmission method to implement best-effort delivery of data. Compared with
FTP, TFTP has a much smaller software size.
Setting Up an Upgrade Environment
Set up an upgrade environment as shown in Figure 7-7 and Figure 7-8.
Figure 7-7 Set up an upgrade environment
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 57 58

Comentarios a estos manuales

Sin comentarios