H3c-technologies H3C WA2600 Series WLAN Access Points Manual de usuario descargar pdf (Pagina 27)

Logging in to the AP

NOTE:

A fit AP is zero-configuration and is managed by an access controller or wireless switch. This chapter

describes how to log in to a fat AP on a web interface.

Use the following factory default settings to log in to a fat AP on a web interface:

• Username: admin

• Password: h3capadmin

• IP address: 192.168.0.50 (mask: 255.255.255.0)

To log in to the AP from a PC:

1. Connect the Ethernet port of the AP to a PC by using an Ethernet cable.

2. Configure an IP address for the PC and make sure that the PC and the AP can reach each other.

For example, assign the PC an IP address (for example, 192.168.0.2) with 192.168.0.0/24

(except 192.168.0.50).

3. Open the browser and input the login information:

a. Input the address http://192.168.0.50 (the default IP address of the AP) in the address bar

and press Enter.

The login page of the web interface (see Figure 18) appears.

b. Enter the default username and password and the verification code, select the language, and

click Login.

Figure 18 Web interface

1 2 ... 22 23 24 25 26 27 28 29 30

Sin comentarios

H3c-technologies H3C WA2600 Series WLAN Access Points Manual de usuario Pagina 27