H3c-technologies H3C WX5500E Series Access Controllers Manual de usuario Pagina 98

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 221
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 97
87
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or port
group view.
Enter Layer 2 Ethernet interface view or
Layer 2 aggregate interface view:
interface interface-type interface-number
Enter port group view:
port-group manual port-group-name
Use one of the commands.
3. Enable digest snooping on
the interface or port group.
stp config-digest-snooping
By default, digest snooping
is disabled on a port.
4. Return to system view.
quit N/A
5. Enable global digest
snooping.
stp config-digest-snooping
By default, digest snooping
is disabled globally.
Configuration example
Network requirements
As shown in Figure 20, Device A and Device B connect to Device C, which is a third-party device. All
these devices are in the same region.
Enable digest snooping on the ports of Device A and Device B that connect to Device C, so that the three
devices can communicate with one another.
Figure 20 Network diagram
Configuration procedure
# Enable digest snooping on GigabitEthernet 1/0/1 of Device A and enable global digest snooping on
Device A.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] stp config-digest-snooping
[DeviceA-GigabitEthernet1/0/1] quit
[DeviceA] stp config-digest-snooping
Vista de pagina 97
1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 220 221

Comentarios a estos manuales

Sin comentarios