H3c-technologies H3C S3100V2 Series Switches Manual de usuario descargar pdf (Pagina 87)

NOTE:

• The reset mld-snooping group command works on only an MLD snooping–enabled VLAN, but canno

work on a VLAN with MLD enabled on its VLAN interface.

• The reset mld-snooping group command cannot remove the static group entries of MLD snooping

groups.

• For more information about the display mac-address multicast command, see the

IP Multicast

Command Reference.

MLD snooping configuration examples

IPv6 group policy and simulated joining configuration example

Network requirements

• As shown in Figure 24, Router A connects to the IPv6 multicast source through Ethernet 1/0/2 and

to Switch A through Ethernet 1/0/1. Router A is the MLD querier on the subnet.

• MLDv1 runs on Router A, MLDv1 snooping runs on Switch A, and Router A acts as the MLD querier

on the subnet.

• The receivers, Host A and Host B, attached to Switch A can receive IPv6 multicast traffic addressed

to IPv6 multicast group FF1E::101 only.

• IPv6 multicast data for group FF1E::101 can be forwarded through Ethernet 1/0/3 and Ethernet

1/0/4 of Switch A even if Host A and Host B accidentally, temporarily stop receiving IPv6 multicast

data.

Figure 24 Network diagram for IPv6 group policy simulated joining configuration

Source

Router A

MLD querier

Switch A

Receiver

Host A

Host B

Host C

1::1/64

Eth1/0/4

Eth1/0/2

Eth1/0/3

Eth1/0/1

2001::1/64

Eth1/0/2

1::2/64

VLAN 100

Configuration procedure

1. Enable IPv6 forwarding and configure IPv6 addresses

Enable IPv6 forwarding and configure an IPv6 address and prefix length for each interface according to

Figure 24. T

he detailed configuration steps are omitted.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 110 111

Comentarios a estos manuales

Sin comentarios

H3c-technologies H3C S3100V2 Series Switches Manual de usuario Pagina 87

Comentarios a estos manuales

Relacionado con productos y manuales para Routers H3c-technologies H3C S3100V2 Series Switches