H3c-technologies H3C S3100V2 Series Switches Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 69
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
30
part.Connect the made connector to the grounding post of the grounding strip, and then fasten it
with a hex nut, as shown in Figure 40.
Figure 39 Make
the grounding cable connector
Figure 40 Connect the grounding cable to a grounding strip
(1) Grounding post (2) Grounding strip
(3) grounding cable (4) Hex nut
Grounding the switch with a grounding conductor buried in the
earth ground
When there is no grounding strip, but an area with exposed earth is available nearby where a
grounding conductor can be buried, you can ground the switch by burying the grounding conductor.
Follow these steps to ground the switch by burying the grounding conductor into the earth:
Step1 Connect the OT terminal of the grounding cable to the switch through the grounding screw on the switch.
Step2 Weld the yellow-green grounding cable to the grounding conductor and treat the joint for corrosion
protection.
Step3 Hammer the grounding conductor into the earth.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 68 69

Comentarios a estos manuales

Sin comentarios