H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario descargar pdf (Pagina 17)

• If the access controller has two main control boards working in active-standby mode, pressing the

reset button on the active main control board causes the system to switch to the standby main control

board. This results in a transient service interruption.

• If the access controller has two main control boards, pressing the reset button on the standby main

control board causes the standby main control board to reboot without affecting system operation.

CAUTION:

• When you press the reset button to restart the access controller, any unsaved confi

uration chan

es will

be lost.

• Do not press the reset button while the access controller is rebootin

or accessin

the CF card or USB

device, as this may damage the file system of the access controller.

LEDs on the main control board panel

Table 9 Description of the LEDs on the main control board panel

LEDs Status Meaning

Off The board is out of position.

RUN

(Green)

Blinking The board is operating normally.

Off The board is out of position or working normally.

SLOT0 to SLOT2

ALM

(Red)

On The board is faulty.

On The fans are operating normally.

(Green)

Off At least one fan is faulty or out of position.

On At least one fan is faulty or out of position.

FAN

FAIL

(Red)

Off The fans are operating normally.

On The board is in active state.

ACTIVE

(Green)

Off The board is in standby state.

Figure 9 LEDs on the EWPX1WCMB0

2 3

1: Slot 0 status LEDs 2: Slot 1 status LEDs

3: Slot 2 status LEDs 4: Fan status LEDs

5: ACTIVE LED

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 89 90

Comentarios a estos manuales

Sin comentarios

H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Routers H3c-technologies H3C WX6000 Series Access Controllers