H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario descargar pdf (Pagina 33)

Connecting interface cables

Connecting the console cable

The console cable is an 8-core cable with an RJ-45 connector at one end for the console port of the

access controller and a DB-9 female connector at the other end for the 9-pin serial port of a PC or console

terminal.

Figure 19 Console cable

1: DB-9 connector 2: Main label

3: RJ-45 connector

Table 18 Console cable pinouts

Pin (RJ-45) Signal Pin (DB-9) Signal

1 RTS 8 CTS

2 DTR 6 DSR

3 TXD 2 RXD

4 SG 5 SG

5 SG 5 SG

6 RXD 3 TXD

7 DSR 4 DTR

8 CTS 7 RTS

Follow these steps to connect the console cable before configuring your access controller through a PC

or console terminal:

Step1 Power off the access controller.

Step2 Connect the DB-9 female connector of the console cable to the serial port of the PC or console terminal.

Step3 Connect the RJ-45 connector of the console cable to the console port of the access controller.

Step4 Verify the connection, switch on the access controller and check whether the console terminal displays

the boot information.

Connecting category-5 cables

The 10Base-T/100Base-TX and 1000Base-T ports of the WX6103 access controller use RJ-45 connectors.

The ports support MDI/MDI-X auto-sensing and work with Category-5 cables.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 89 90

Sin comentarios

H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario Pagina 33