H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario descargar pdf (Pagina 575)

100

101

61-4

z The debugging commands are usually used by administrators in diagnosing network failure.

z Output of the debugging information may reduce system efficiency, especially during execution of

the debugging all command.

z After completing the debugging, you are recommended to use the undo debugging all command

to disable all the debugging functions.

z You must configure the debugging, terminal debugging and terminal monitor commands first

to display the detailed debugging information on the terminal. For the detailed description on the

terminal debugging and terminal monitor commands, refer to the Information Center in H3C

WX6103 Access Controller Switch Interface Board Command Reference.

System Maintaining Example

Network requirements

z The IP address of the destination device is 10.1.1.4.

z Display the routers used while packets are forwarded from the current device to the destination

device.

Network diagram (omitted here)

Configuration procedure

<Sysname> tracert 10.1.1.4

traceroute to 10.1.1.4 30 hops max, 40 bytes packet

1 128.3.112.1 19 ms 19 ms 0 ms

2 128.32.216.1 39 ms 39 ms 19 ms

3 128.32.136.23 39 ms 40 ms 39 ms

4 128.32.168.22 39 ms 39 ms 39 ms

5 128.32.197.4 40 ms 59 ms 59 ms

6 131.119.2.5 59 ms 59 ms 59 ms

7 129.140.70.13 99 ms 99 ms 80 ms

8 129.140.71.6 139 ms 239 ms 319 ms

9 129.140.81.7 220 ms 199 ms 199 ms

10 10.1.1.4 239 ms 239 ms 239 ms

The above output shows that nine routers are used from the source to the destination device.

1 2 ... 570 571 572 573 574 575 576 577 578 579 580 ... 677 678

Comentarios a estos manuales

Sin comentarios

H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario Pagina 575

Comentarios a estos manuales

Relacionado con productos y manuales para Routers H3c-technologies H3C WX6000 Series Access Controllers