H3c-technologies H3C SecPath F100-C-SI Manual de usuario Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 26
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
5
Caution: To ensure the equipment is mounted on the wall firmly, please
use a screw at least 3 mm diameter and the screw head at least 6.5 mm
diameter.
Achtung: Um das Gerät an der Wand zu befestigen, benutzen Sie
Nagel mit einem Mindestdurchmesser von 3 mm. Der Durchmesser der
Nagelkappe muss mindestens 6.5 mm betragen.
注意:为确保设备紧固的安装在墙上,请用直径最小是
3mm
螺钉,并
且螺帽的直径要大于
6.5mm
Warning: The unit must be permanently connected to the protective
ground before operation. The cross-sectional area of the protective
earthing / grounding conductor shall be at least 0.75 mm
2
or 18 AWG.
Warnung: Diese Anlage muss vor der Inbetriebnahme ständig an den
Schutzleiter angeschlossen werden. Die Querschnittsfläche des
Schutzerdungsleiters soll mindestens 0.75 mm
2
oder 18 AWG
betragen.
警告:进行设备操作前,请确保设备永久接地,并且确保接地线截面
不小于
0.75 mm
2
18 AWG
Warning Power Cord Table:
The power cord set must be approved for the country where it is used.
WARNUNG Netzkabel Tabelle:
Das Netzkabel muss für das Land, in dem es verwendet wird,
zugelassen werden.
警告:电源线表格:
电源线组件必须满足使用的国家认证要求。
U.S.A. and
Canada
The cord set must be UL approved and CSA certified
The minimum specification for the flexible cord is:
No. 18 AWG
Type SV / SVT or SJ / SJT or SPT-2
3 conductor.
The cord set must have a rated current carrying
capacity of at least 10A.
The attachment plug must be an earth-grounding
type with a NEMA 5-15P (15A, 125V) or NEMA
6-15P (15A, 250V) configuration
United
Kingdom
The supply plug must comply with BS1363 (3-pin,
13A) and be fitted with a 5A fuse that complies with
BS1362
The mains cord must <HAR> or <BASEC> marked
and be of type H03VVF3G0.75 (minimum).
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comentarios a estos manuales

Sin comentarios