H3c-technologies H3C SecPath F1000-E Manual de usuario Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 57
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
7
To do… Use the command… Remarks
Enter Ethernet subinterface view
interface interface-type
interface-number.subnumber
Set the broadcast suppression
threshold ratio
broadcast-suppression ratio
Optional
By default, broadcast traffic is not
suppressed.
Set the multicast suppression
threshold ratio
multicast-suppression ratio
Optional
By default, multicast traffic is not
suppressed.
Set the unknown unicast
suppression threshold ratio
unicast-suppression ratio
Optional
By default, unknown unicast traffic
is not suppressed.
Configuring Jumbo Frame Support
An Ethernet interface may receive some frames larger than the standard Ethernet frame size (called
jumbo frames) during high-throughput data exchanges such as file transfers. Usually, an Ethernet
interface discards jumbo frames. With jumbo frame support enabled, the interface can process frames
larger than the standard Ethernet frame size yet within the specified range.
In Ethernet interface view, you can set the length of jumbo frames that are allowed to pass through the
Ethernet interface.
Follow these steps to configure jumbo frame support in interface view:
To do… Use the command… Remarks
Enter system view
system-view
Enter Ethernet interface view
interface interface-type
interface-number
Configure jumbo frame support
jumboframe enable
[ value ]
Optional
By default, the device allows jumbo frames
within the specified length to pass through
all Layer 2 Ethernet interfaces.
If you set the value argument multiple times,
the latest configuration takes effect.
Setting the MDI Mode of an Ethernet Interface
NOTE:
Optical interfaces do not support the MDI mode setting.
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Comentarios a estos manuales

Sin comentarios