H3c-technologies H3C SecPath M9000 Series Manual de usuario descargar pdf (Pagina 26)

Figure 17 Installing a card

Installing a power module

CAUTION:

• Do not install AC power modules and DC power modules on the same gateway.

• Select power modules according to the power supply at the installation site.

• Provide a circuit breaker for each power module and make sure the circuit breaker is off before installin

the power module.

Some power module slots do not have a blank filler panel. The figures in this section are for illustration

only.

An AC power module and a DC power module are installed in the same way. This section uses an AC

power module as an example.

To install the power module:

1. Use a Phillips screwdriver to loosen the captive screws on the blank filler panel (if any) to remove

the blank filler panel.

2. Follow the installation graph printed on the blank filler panel of the power module to install the

power module in a correct direction:

a. Grasp the handle of the module with one hand and support the module bottom with the other.

b. Push the power module along the guide rails into the slot until it has firm contact with the slot.

For vertical slot installation, see Figure 18. For horizontal slot installation, see Figure 19.

3. Press the han

dle inward until the handle seats into the slot.

4. Use a Phillips screwdriver to fasten the captive screw on the handle to attach the power module.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 97 98

Sin comentarios

H3c-technologies H3C SecPath M9000 Series Manual de usuario Pagina 26