H3c-technologies H3C SecPath F1000-E Manual de usuario descargar pdf (Pagina 51)

Initiator:

Source IP/Port : 2001::0002/32768

Dest IP/Port : 3001::0005/43986

VPN-Instance/VLAN ID/VLL ID:

Responder:

Source IP/Port : 8.0.0.2/0

Dest IP/Port : 9.0.0.5/43986

VPN-Instance/VLAN ID/VLL ID:

Pro: ICMPv6(58) App: unknown State: ICMP-CLOSED

Start time: 2011-07-20 19:09:48 TTL: 25s

Root Zone(in):

Zone(out):

Received packet(s)(Init): 5 packet(s) 520 byte(s)

Received packet(s)(Reply): 5 packet(s) 420 byte(s)

Troubleshooting NAT-PT

Symptom

NAT-PT fails when a session is initiated on the IPv6 side.

Solution

• Enable debugging for NAT-PT and locate the fault according to the debugging information of the

firewall.

• During debugging, check whether the source address of a packet is translated successfully. If not,

it is possible that the address pool has no sufficient IP addresses.

• You can configure a larger address pool, or use NAPT-PT to perform NAT-PT.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Sin comentarios

H3c-technologies H3C SecPath F1000-E Manual de usuario Pagina 51