H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario descargar pdf (Pagina 62)

5-2

z For a low-speed network, you are recommended to set a larger value for the timeout timer

(indicated by the -t parameter in the command) when configuring the ping command.

z Only the directly connected segment address can be pinged if the outgoing interface is specified

with the -i argument

z Support for IPv6 depends on the device model.

Ping Configuration Example

Network requirements

As shown in Figure 5-1, check whether an available route exists between Device A and Device C. If

there is an available route exists between the two devices, get the detailed information of routes from

Device A to Device C.

Figure 5-1 Ping network diagram

Configuration procedure

# Use the ping command to display whether an available route exists between Device A and Device C.

<DeviceA> ping 1.1.2.2

PING 1.1.2.2: 56 data bytes, press CTRL_C to break

Reply from 1.1.2.2: bytes=56 Sequence=1 ttl=254 time=205 ms

Reply from 1.1.2.2: bytes=56 Sequence=2 ttl=254 time=1 ms

Reply from 1.1.2.2: bytes=56 Sequence=3 ttl=254 time=1 ms

Reply from 1.1.2.2: bytes=56 Sequence=4 ttl=254 time=1 ms

Reply from 1.1.2.2: bytes=56 Sequence=5 ttl=254 time=1 ms

--- 1.1.2.2 ping statistics ---

5 packet(s) transmitted

5 packet(s) received

0.00% packet loss

round-trip min/avg/max = 1/41/205 ms

# Get the detailed information of routes from Device A to Device C.

<DeviceA> ping -r 1.1.2.2

PING 1.1.2.2: 56 data bytes, press CTRL_C to break

Reply from 1.1.2.2: bytes=56 Sequence=1 ttl=254 time=53 ms

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 178 179

Sin comentarios

H3c-technologies H3C WX6000 Series Access Controllers Manual de usuario Pagina 62