H3c-technologies H3C SecBlade NetStream Cards Manual de usuario descargar pdf (Pagina 38)

ect Re

uirements

Terminal

Run the hyper terminal program.

Configure the hyper terminal attributes.

The port properties of the hyper terminal must be the same as the default settings of the console port

shown in the following table.

Settin

Default

Bits per second 9,600 bps

Flow control None

Parity None

Stop bits 1

Data bits 8

Step1 As shown in Figure 4, use the console cable shipped with the SecBlade card to connect the PC and the

SecBlade card. Plug the DB-9 connector of the console cable into the serial port of the PC, and plug the

RJ-45 connector into the console port of your SecBlade card.

Figure 4 Connect the SecBlade card and PC through a console cable

ARNING!

Identify interfaces correctly to avoid connection errors.

NOTE:

The serial port of a PC does not support hot-swap. Do not plug or unplug the console cable to or from the

PC when your SecBlade card is powered on. To connect the PC to the SecBlade card, first plug the DB-9

connector of the console cable into the PC, and then plug the RJ-45 connector of the console cable into

your SecBlade card. To disconnect the PC from the SecBlade card, first unplug the RJ-45 connector and

then the DB-9 connector.

Step2 Launch a terminal emulation program (such as HyperTerminal in Windows XP/Windows 2000). The

following takes the HyperTerminal of Windows XP as an example. Select a serial port to be connected

to the SecBlade card, and set terminal parameters as follows: set Bits per second to 9600, Data bits to

8, Parity to None, Stop bits to 1, and Flow control to None, as shown in Figure 5 thr

ough Fi

gure 7.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 348 349

Sin comentarios

H3c-technologies H3C SecBlade NetStream Cards Manual de usuario Pagina 38