H3c-technologies H3C SecBlade NetStream Cards Manual de usuario descargar pdf (Pagina 99)

3. Flexible virtual workgroup creation. As users from the same workgroup can be assigned to the

same VLAN regardless of their physical locations, network construction and maintenance is much

easier and more flexible.

VLAN fundamentals

To enable a network device to identify frames of different VLANs, a VLAN tag field is inserted into the

data link layer encapsulation.

The format of VLAN-tagged frames is defined in IEEE 802.1Q issued by the Institute of Electrical and

Electronics Engineers (IEEE) in 1999.

In the header of a traditional Ethernet data frame, the field after the destination MAC address and the

source MAC address is the Type field indicating the upper layer protocol type, as shown in Figure 27.

Figure 27 Traditional Et

hernet frame

format

IEEE 802.1Q inserts a four-byte VLAN tag after the DA&SA field, as shown in Figure 28.

Figure 28 Position and format of VLAN tag

A VLAN tag comprises the following fields: tag protocol identifier (TPID), priority, canonical format

indicator (CFI), and VLAN ID.

• The 16-bit TPID field with a value of 0x8100 indicates that the frame is VLAN-tagged.

• The 3-bit priority field indicates the 802.1p priority of the frame.

• The 1-bit CFI field specifies whether the MAC addresses are encapsulated in the standard format

when packets are transmitted across different media. A value of 0 indicates that MAC addresses

are encapsulated in the standard format; a value of 1 indicates that MAC addresses are

encapsulated in a non-standard format. The value of the field is 0 by default.

• The 12-bit VLAN ID field identifies the VLAN the frame belongs to. The VLAN ID range is 0 to 4095.

As 0 and 4095 are reserved, a VLAN ID actually ranges from 1 to 4094.

A network device handles an incoming frame depending on whether the frame is VLAN tagged and the

value of the VLAN tag, if any. For more information, see “Introduction to port-based VLAN.”

NOTE:

• The Ethernet II encapsulation format is used here. Besides the Ethernet II encapsulation format, Etherne

also supports other encapsulation formats, including 802.2 LLC, 802.2 SNAP, and 802.3 raw. The

VLAN tag fields are added to frames encapsulated in these formats for VLAN identification.

• For a frame with multiple VLAN tags, the device handles it according to its outer-most VLAN tag and

transmits its inner VLAN tags as payload.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 348 349

Sin comentarios

H3c-technologies H3C SecBlade NetStream Cards Manual de usuario Pagina 99